If you have any questions on how the kill switch works or how to install it feel free to call our customer service line (210)385-8153

*2017-2019 6.7L Powerstrokes are a little more difficult to install because you need to pull the right front fender liner and tire off to reach the starter. It should take between 2-3 hours to install.

The reason our price is the price is because we spend over 3 hours hand making the switches so that away it is a simple easy plug and play design and takes you the consumer less than 30 min to install. 

Best kill /starter interrupt switch system on the market. 

Plug and play Minimal wiring. 

Vehicle is always armed.  No need to remember to set the switch. (Unless you have manually overrode to valet/service mode)

Waterproof components. Relays, switch and wire connections. No electronics to fail.  Manual override/valet / service mode. If someone needs to drive your vehicle and you don’t want them to know where the switch is. 

Quality components that are made to last.  Quality Tinned corrosion resistant multi-stranded flexible vibration resistant wire. High temp wire insulation resistant to oil, gasoline, fuels, alkali, moisture, abrasion and heat.  Waterproof heat shrink on connectors to protect against corrosion, chafe resistance and provide strain relief. 

Sleeving on harness is heat and abrasion resistant Wire meets or exceeds automotive, marine USCG ABYC industrial specifications. 

No wires are cut.

Easily removable and reverted back to factory setting if necessary. For instance, if you sell your vehicle and you want to keep the system. 

Separate horn included.  Can also wire into the factory horns if desired. 

Heavy duty water/dirt resistant 50 amp switch with manual override/valet/service mode

No drain on battery!!!

All necessary parts and hardware and grommet tool are included.  Some basic wiring skills will be required.  Test light or voltmeter and a good set of wire crimpers may be required for installation on some models. 

Designed to blend in with the factory wiring. Looks OE.  Can be installed on autos, trucks, industrial equipment. 

If you live in the San Antonio, Boerne, or Helotes area and would like to have your kill switch installed by us please give us a call (210)385-8153 (price is between $300-$400 parts and labor included)

What's included:

-Step by step instructions install is as little as 30 minutes 

-Video of how to install 

-All the wiring needed (it is pre cut and measured for faster installation) 

-Kill switch (includes a valet/service mode) 

-2 Separate horns from factory horn is included 

-Relay 

-Wire connectors 

-Mounting screws 

-Relay holders

Have you gotten your truck broken into? Well if you have then you definitely need to add a extra layer of protection by using this honking kill switch. The beauty of our honking kill switch is it uses a separate hidden horn that thieves cannot find and cut because that is the first thing thieves do is cut your horn. This is my dads design he is an auto mechanic of 40 years and knows what he is doing. So if you never want your Truck stolen than pick up your kill switch today. 

Vehicle Fitment: WE SELL KILL SWITCHES FOR ALL VEHICLES. WETHER YOU HAVE A CAR OR A TRUCK JUST ENTER THE INFO BELOW AND WE CAN GET THE SWITCH PREPARED FOR YOU. 

DISCLAIMER: IF YOU USE START STOP FEATURE YOU CANNOT USE YOUR TRUCK UNLESS YOU BYPASS THE SWITCH OR DISCONNECT THE START STOP FEATURE 

Why We Made This Honking Kill Switch

My family and friends have been battling with thieves for the past 10 years we have had trailers stolen, trucks stolen, and boats stolen. So we finally said enough is enough and we came out with this honking kill switch. My entire family and majority of my friends have this kill switch installed on there vehicle and personally I would never drive my vehicle again without it. It has saved my truck twice.